Position Light Adapter for Fog Light Scania NextGen 2016–2022
LED light plates designed to create a stylish light in the fog light on Scania Next Generation with LED headlights. This kit includes 2 light plates, 1 for each side.
Suitable for Scania Next Generation model years 2016–2022.
The light from the plates does not dazzle oncoming vehicles, and you still retain the standard fog light function.
Available in 4 different colours and 3 different versions: single-colour, dual-colour or dual-colour with strobe light.
Single-colour – Xenon White / Warm White / Amber / Yellow
Each light plate has a 3 metre cable which should be connected to, for example, a position light or alternatively to a switch if you want to be able to turn the reflector light off. There is one positive and one negative cable.
Dual-colour – Xenon White & Amber or Warm White & Amber
Each light plate has a 3 metre cable with one negative cable and two positive cables, one for each colour, allowing you to switch between them. Can be connected to, for example, a switch or relay.
Strobe Light & Dual-colour – Xenon White & Amber with Strobe or Warm White & Amber with Strobe
The light plate has a 6 metre cable with M8 connectors, which should be connected to the included control unit. The controller manages the two colours and automatically switches them off when the flashing light is activated.
To control the unit, there is an outgoing cable with 4 wires:
Negative – Green cable
Positive for white position light – White cable
Positive for yellow position light – Yellow cable
Positive for flashing light – Brown cable
During installation, the cables with the M8 connectors need to be cut, so make sure the joint is made waterproof and that the wires are connected to the correct colours.
Installation:
Remove all screws from the top of the lamp.
The heat sink is glued to the lamp, so you need to cut along the edge using, for example, a craft knife. See the image of the heat sink from above, where a red dashed line marks where you need to cut. Separate the lamp, for example by using two flat screwdrivers to help release the glue.
Remove as much of the original glue as possible.
Drill a hole in the lamp according to the marking. Feed the cable from the light plate through the hole. Make sure not to damage the cable. It may be beneficial to countersink the hole first. Make sure to seal the hole again.
Remove the two outer screws on the original light plate and place the two spacers over the holes. Place the new light plate on top of the existing one, with the LEDs facing outwards. The light plate is secured using the included M4 x 8 mm screws. Glue and screw the lamp back together again.
Scania is a registered trademark and the use of the name is for reference purposes only. This product is not an original part and is not manufactured or approved by Scania. The use of the trademark name is only to indicate that the part is suitable for the truck.
